A gold shaker table contains a water access point where you can fill it with clean water, which can be seen right under the control area. Alternatively you can directly fill the tank of the shaker table with clean water. The water access point allows you to connect a clean water system through a garden hose. The valve that is right behind the tank is then turned off and the pump system is not running during the process of running fresh water. When clean washing water is distributed at the top of the table at right angles, particles are moved diagonally across the deck and separate from each other according to their size and density.
During the fast shaking process, you will gradually begin to see the separation of materials. For example, when you have dirt and rocks that contain materials like lead, sulfides and gold, because of the varying weights of these different materials, you will see these materials venture off in different directions on the shaker table. The lead and the sulfides will be carried over to the right side of the table while the pure gold will be carried over to the far left side of the table.
There is one term to remember when professional gold miners describe the actions of a gold shaker table. When professional gold miners say that small particles of gold are being carried through the grooves, they are referring to the ripples that you can plainly see on the shaker table. When they say that there is an overflow of materials like Black Pyrrhotite, White Quartz, silver and gold on the grooves, then this is a good thing.
When materials are washed by the clean water they are supposed to drop into 3 hoppers/launders underneath the table. There is a centre launder that will gather the purest portions of gold while the two outside launders will gather some gold, though not as much.
It is crucial to remember to plug the cable of your shaker table into a GFCI (Ground Fault Circuit Interrupter) outlet. Most shaker tables will not work if they are plugged into any other kind of outlet.
Gold Shaking Table
Gold shaker tables are environmentally friendly (chemical free) for recovering pure gold as they can play an important part in reducing the use of mercury by gold miners. With gold shaker tables miners don’t need to resort to mercury amalgamation or cyanide to recover gold. The filter will constantly need to be removed and cleaned as it will get dirty even after using the table a few times.
Miners can design and construct a basic shaking table out of cheap materials that are affordable in local stores, including a drive mechanism that contains bicycle gears, chains and rubber bands that are made from car tire inner tubes. The drive mechanism for a gold shaker table can be a hand crank or it can contain parts of a motorcycle frame and engine. If one prefers to use a motor for his or her table, either an electric motor or a motor that runs on diesel fuel would be the ideal options.
It is important to keep in mind that there is no one specific way to create your own gold shaker table system. Many professional gold mining organizations will create tables of different shapes and sizes to cater to the needs of their customers. Some shaker table systems will feature machines that can crush hard rocks, which are referred to as jaw crushers. The speeds of shaker table systems will vary as they can shake from hundreds to thousands of pounds of materials per hour.